3516C

Back to

The 3516C propulsion engine is available with a wide range of ratings that meet IMO II regulations without any additional aftertreatment. These engines provide efficient operation with electronic governing, cold mode start strategy, and programmable low idle to minimize fuel consumption. The 3516C engine also incorporates a closed crankcase ventilation system to lower emissions.

Pricing: Contact for Pricing

Power Range 2000-3385 bhp (1492-2525 bkW)
Aspiration TTA
Bore 8.46in
Configuration V 16, 4-Stroke-Cycle Diesel
Displacement 4765in³
Emissions IMO II
Rotation from Flywheel End Counterclockwise or Clockwise
Speed Range 1200-1800 rpm
Stroke 7.48in
Maximum Height 84.6in
Maximum Length 148in
Maximum Width 84.3in
Minimum Height 77.4in
Minimum Length 143.1in

Standard Equipment:

  • Air Inlet System
    • Corrosion resistant separate circuit freshwater aftercooled, powercore air cleaner
  • Control System
    • Dual Caterpillar® A3 Electronic Control Unit (ECU) LH with electronic unit injector fuel system rigid wiring harness (10 amp DC power required to drive ECU)
  • Cooling System
    • Gear-driven centrifugal auxiliary sea water pump, geardriven centrifugal jacket water pump, expansion tank for commercial engines, coolant shunt tank on lightweight engines, engine oil cooler, thermostats and housing.
  • Ecu Functions
    • Programmable low idle, SAEJ1939 data link, Cat® data link, engine diagnostics, general alarm relay, programmable parameters (system application and tattletales), Caterpillar ET service tool interface, remote shutdown, shutdown notify, load feedback, overspeed shutdown, overspeed verify
  • Exhaust System
    • Dry gas-tight exhaust manifolds with heat shields, dual turbochargers with watercooled bearings and heat shield. Wastegate on select ratings
  • Fuel System
    • Electronically controlled unit injectors, simplex fuel filter (RH) with service indicators, fuel transfer pump
  • Instrumentation
    • Marine Power Display of: Engine oil pressure, engine water temperature, fuel pressure, engine speed, fuel consumption, overspeed shutdown notification light, prelube and shutdown override
  • Lube System
    • Gear-driven pump, top-mounted dual crankcase breather groups, simplex oil filter, oil filler and dipstick
  • Power Take-offs
    • Accessory drive, two-sided front housing
  • Protection System
    • Emergency stop pushbutton, safety shutoff, oil pressure, and water temperature
  • General
    • Two lifting eyes mounted to cylinder heads, Caterpillar yellow paint, parts books and maintenance manuals, shrink-wrap.
  • Iso Certification
    • Factory-designed systems built at Caterpillar ISO 9001:2000 certified facilities.

Optional Equipment:

  • Air Inlet System
    • Air Cleaner Removal
    • Remote Air Inlet Adapters
  • Charging System
    • Battery Chargers
    • Charging Alternators
  • Control System
    • Throttle Position Sensor
    • Throttle Synchronization
  • Cooling System
    • Water Level Switch Gauge
    • Coolant Level Sensors
    • Connections
    • Keel Cooling Conversions
    • Heat Exchangers
    • Auxiliary Water Pumps
    • Sea Water Pump Removal
    • Coolant Shunt Tanks
    • Air Separator
    • Marine Gear Cooling
  • Exhaust System
    • Exhaust Outlet
    • Flexible Fittings
    • Elbows
    • Flanges
    • Flange and Exhaust Expanders
    • Mufflers
  • Fuel System
    • Fuel Cooler
    • Fuel Priming Pumps
    • Flexible Fuel Lines
    • Rigid Fuel Lines
    • Primary Fuel Filter
    • Fuel level switch
  • Instrumentation
    • PL1000T Communication Module
    • PL1000E Communication Module
    • Customer Interface
    • Thermocouples
    • Remote Panel Display
    • Remote Cylinder Temperature Display
    • Pilot House Instrument Panels
    • Marine Gear Sensors
    • Engine Vision Display System
  • Lube System
    • Oil Pan
    • Oil Pan Accessories
    • Sump Pumps
    • Prelubrication Options
    • Lubricating Oil
    • CENTRIFUGAL OIL FILTER
  • Mounting System
    • Engine Supports
    • Vibration Isolation Mountings
  • Power Take-offs
    • Flexible Coupling and Guards
    • Front Housing Accessories
    • Upper Left Hand Front Location:
    • Upper Right Hand Front Location:
    • Upper Right Hand Rear Location:
    • Lower Left Hand Front Location:
    • Lower Left Hand Rear Location:
    • Front Housing Accessory Drives
    • Upper LH Accessory Drive
    • Upper RH Accessory Drive
    • Front Power Take Offs
    • Crankshaft Pulleys
    • Damper Guard Removals
  • Protection System
    • Air Inlet Shutoffs
    • Switches and Contactors
    • Explosion Relief Valve
    • Sensors
  • Spare Parts Kits
    • Parts Kits
    • Pump Kits
    • Fuel Transfer
    • Lube Oil
  • Special Appearance
    • Chrome Plated Relief Valves
    • Black Air Cleaners
  • Starting System
    • Starting Motors or Barring Device
    • Air Starting Motors Options
    • Starting Aids
    • Battery Sets - 24 Volt - Dry
    • Battery Rack
  • General
    • Tool Set
    • Caterpillar Datalink Wire

What Our Customers Are Saying About Us

Renee HerndonRenee Herndon
21:55 29 Feb 24
Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.
David LawrenceDavid Lawrence
13:04 22 Feb 24
Brandon PierceBrandon Pierce
22:00 18 Feb 24
Darin NoeDarin Noe
01:17 16 Feb 24
Jose SotoJose Soto
15:26 23 Sep 23
Hunter ElliottHunter Elliott
16:17 07 Sep 23
Rick Kelly-CrapseRick Kelly-Crapse
21:06 25 Aug 23
They had all my parts for my 3208 Cat.Friendly folks at parts counter.
js_loader