DG250-2 (3 phase)

Standard Equipment:

• Cooling

  • Factory-installed radiator
  • Closed coolant recovery system
  • 50/50 Ethylene glycol antifreeze
  • Standard ambient temperatures up to 50°C (122°F)
  • Radiator and cooling fan complete with protective guards

• Air Inlet

  • Single element air filter

• Fuel

  • Low fuel pressure switch
  • Fuel pressure test po
  • Primary and secondary fuel shut-off
  • Dual lock off valves
  • NPT connection
  • Natural Gas or LP Vapor

• Generator

  • Class H insulation material
  • Full load capacity alternator
  • Permanent magnet excitation
  • Full load capacity alternator
  • Permanent magnet excitation
  • Matched to the performance and output characteristics of Cat engines
  • Integrated Voltage Regulator
  • Class H insulation material
  • IP23 Protection

• Exhaust

  • Exhaust outlet with 3” pipe

• Controls

  • EMCP 4.2 Series generator set controller

• Mounting

  • Vibration isolaton (puck type)
  • Rubber vibration isolators

• Electric Starting And/or Prelube

  • Solenoid activated starter motor
  • Engine electrical system
  • Battery cables
  • Solenoid activated starter motor

• Electric Power - Package Serial Number Prefix

  • Battery charging alternator

• Governor

  • Electronic governor (non adjustable)

• Control Panel

  • EMCP 4.2 Series generator set controller

• Starting/charging

  • 12 volt starting motor
  • Batteries with rack and cables

Optional Equipment:

• Starting/charging

  • Battery heater
  • Battery charger – UL Listed 10 amp
  • Jacket water heater
  • Charging alternator

• General

  • CSA Certification
  • Suitable for Use as Service Equipment (SUSE)
  • UL 2200 package
  • Enclosures: sound attenuated, weather protective
  • Automatic transfer switches (ATS)

• Generator

  • Shunt trip and auxiliary contact breaker
  • Anti-condensation heater
  • Thermal magnetic or electronic trip MCCBs
  • Oversize and premium generators
  • Excitation: [ ] Permanent Magnet Excited (PM)
  • Anti-condensation heater