3606 Generator Set (Medium Speed)

Duty Cycle	Continuous
Emissions/Fuel Strategy	Low Fuel Consumption
Frequency	50 Hz
Maximum Rating	2688 kVA
Minimum Rating	1775 kVA
Speed	750 & 1000 rpm

Aspiration	TA
Bore	11in
Compression Ratio	13:01
Displacement	6762in³
Engine Model	3606 I-6, 4-Stroke Water-Cooled Diesel
Fuel System	Direct unit injection
Governor Type	Generator Set Monitoring System (GMS)
Stroke	11.8in

Dry Weight - Genset (maximum)	74970lb
Height - Maximum	156.6in
Length - Maximum	404in
Width - Maximum	99.62in

Standard Equipment:

Air Inlet System
- Breather, crankcase, top-mounted
- Air inlet shutoff
- Turbocharger, watercooled (750 rpm and HFO), engine oil lubricated
- Aftercooler, fresh water, corrosion resistant coated (air side)
Cooling System
- Water temperature regulator
- Engine coolant water drains
- Jacket water thermostats
Exhaust System
- 457 mm (18 in) Cat bolt pattern
- Dry, gas tight, exhaust manifold
- Includes adapter, Flexible exhaust fitting
Fuel System
- Simplex or Duplex
Generator System
- Custom generator per generator data sheet completed by dealer
Governor System
- UG Actuator
Lube System
- Oil pressure regulating valve
- Wet oil sump. Includes engine-driven main lubrication & oil pumps, Oil Lines and Oil Pan
- Oil filler and dipstick
- Crankcase explosion relief valves
- Service side engine mounted on cylinder block inspection covers
- Centrifugal oil filters with single shutoff
Mounting System
- Damper, torsional vibration
- Engine and generator mounting
Starting / Charging System
- One motor, engine mounted at rear, on left side
- Vane type air starter
- Air silencer
- Line group for single point custom connection
General:
- Paint, Caterpillar yellow
- Gear driven pumps: Fuel, Oil, Jacket water, Aftercooler / Oil cooler water

Optional Equipment:

Air Inlet System
- Boost control valve
- Soot filter
- Heavy duty air cleaner
- Air inlet adapter
- Vertical support bracket
- Air cleaner louver assembly
- Air cleaner
Cooling System
- Expansion tank
- Auxiliary water pump
- Cooling system aids
- Heating aids
Exhaust System
- Weld flange and related hardware
- Flexible exhaust fittings
Fuel System
- Fuel system connections
- Duplex primary fuel strainer
- Fuel priming pump
Generator System
- Class F insulation
- 3 Phase, six Leads, WYE
- Anti-condensation space heaters
- Winding temperature detectors
- Busbar connections
Governor System
- Electronic / actuators
- Digital programmers
- 2301 A load share
- EGB actuator
- Battery backup / Power supply
- 723 Plus
Lube System
- Oil pan drain valve
- Lube ANSI adapter (Emergency connection)
Mounting System
- Non-vertically restrained
- Spring type vibration isolator
- Vertically restrained
- Isolator
Starting / Charging System
- Compressed air flex hose
- Pressure reducing valve
General:
- Custom paint colors

What Our Customers Are Saying About Us

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

What Our Customers Are Saying About Us

Contact Us Today