990K Millyard Arrangement Wheel Loader

Bore	5.4in
Displacement	1649.5in³
Emissions	U.S. EPA Tier 4 Final or Tier 2 equivalent
Engine Model	Cat® C27 ™
Gross - ISO 14396	752HP
Net Power	699HP
Net Power - SAE J1349	699HP
Peak Torque - 1,200 rpm	2624lb/ft
Rated Speed	1,800/min
Rated Speed - Gross - ISO 14396	752HP
Rated Speed - Gross - SAE J1995	766HP
Rated Speed - Net Power - SAE J1349 - High Ambient	648HP
Rated Speed - Net Power - SAE J1349 - Standard Ambient	699HP
Stroke	6in
Torque Rise	18%

Operating Weight	202398lb
Tipping Load - Articulated 35°	81896lb
Tipping Load - Straight	92990lb

Direct Drive - Forward 1	Lock-up disabled
Direct Drive - Forward 2	8.5mile/h
Direct Drive - Forward 3	15.2mile/h
Direct Drive - Reverse 1	5.4mile/h
Direct Drive - Reverse 2	9.6mile/h
Direct Drive - Reverse 3	16.4mile/h
Forward - 1	4.5mile/h
Forward - 2	8.3mile/h
Forward - 3	14.2mile/h
Note	Travel speeds based on Michelin 45/65R39 LD D2**L5 tires.
Reverse - 1	4.9mile/h
Reverse - 2	9.1mile/h
Reverse - 3	15.5mile/h
Transmission Type	Cat-Planetenlastschaltgetriebe

Front	Fixed
Oscillation Angle	8.5°
Rear	Trunnion

Dump	2.9s
Lower	3.7s
Lower Float Down	3.6s
Rack Back	4.8s
Raise	9.4s

Cooling System	54.9gal (US)
Differential - Final Drives - Front	71.6gal (US)
Differential - Final Drives - Rear	68.9gal (US)
Engine Crankcase	20gal (US)
Fuel Tank	294.3gal (US)
Hydraulic System Factory Fill	210gal (US)
Hydraulic Tank - Implement and Hydraulic Fan	68.9gal (US)
Hydraulic Tank - Steering and Braking	34.9gal (US)
Transmission	29.1gal (US)

Cylinders, Double Acting - Lift, Bore and Stroke	254 mm × 1264 mm (10.0 in × 49.8 in)
Cylinders, Double Acting - Tilt, Bore and Stroke	317.5 mm × 819 mm (12.5 in × 32.2 in)
Lift/Tilt System	Variable displacement piston
Lift/Tilt System - Circuit	Positive flow control
Maximum Flow at 1,800 rpm (1)	216gal/min
Maximum Flow at 1,800 rpm (2)	22.2gal/min
Pilot System	Open loop and pressure reducing
Relief Valve Setting - Lift/Tilt	4786psi
Relief Valve Setting - Main	507psi

Maximum Flow at 1,400 rpm	94.5gal/min
Relief Valve Setting - Steering	4641psi
Steering System - Circuit	Pilot, load sensing
Steering System - Pump	Piston, variable displacement
Total Steering Angle	70°

Machine Sound Level (ISO 6395:2008)	115dB(A)
Operator Sound Level (ISO 6396:2008)	69dB(A)

Machine Sound Level (ISO 6395:2008)	113dB(A)
Operator Sound Level (ISO 6396:2008)	69dB(A)

Dump Angle at Maximum Lift	29.3 degrees
Fork Height at Maximum Lift	18.3ft
Fork Height with Level Arms	8.9ft
Fork Top Clamp Opening	12.3ft
Front Axle Centerline to Fork Tip	17.6ft
Ground to Bumper Clearance	3.1ft
Ground to Center of Front Axle	3.9ft
Ground to Lower Hitch Clearance	2ft
Ground to Top of Exhaust Stacks	16.6ft
Ground to Top of Hood	12.7ft
Ground to Top of ROPS	17.2ft
Hinge Pin Height at Maximum Lift	19.4ft
Maximum Overall Length	45.4ft
Rear Axle - Centerline to Bumper	12.5ft
Wheel Base	15.1ft

Fork End Area	78ft²

Brakes	SAE J1473 OKT90, ISO 3450:1992

Standard Equipment:

Standard and optional equipment may vary. Consult your Cat dealer for details.

Air conditioner and heater with automatic temperature control
Cab, sound-suppressed pressurized, protective structure (ROPS/FOPS), radio ready for (entertainment) includes antenna, speakers and converter (12V, 10-15 amp)
12V power port for mobile phone or laptop connection
Camera, rear vision
Cigar lighter and ashtray
Coat hook
Electro-hydraulic tilt and lift controls (seat mounted)
Flip-up armrest
Heater and defroster
Horn, electric
Implement hydraulic lockout
Instrumentation, gauges: – Engine coolant temperature – Fuel level – Ground speed – Gear – Hydraulic oil temperature – Speedometer/tachometer – Torque converter temperature
Instrumentation, warning indicators: – Action alert system, three category – Automatic transmission model enable status – Brake malfunction – Bucket float status – Delayed engine shutdown status – Engine idle shutdown status – Engine malfunction – Fuel economy mode enable status – Hydraulic lockout – Lockup clutch enable status – Low fuel level – Parking brake status – Rimpull control enable status – Seatbelt warning – Secondary steering (if equipped) – Throttle lock status – Transmission gear
Keypad, control with indicator lights: – Auto trans mode speed range – Auto/manual transmission mode – Fuel economy mode – Implement kickout – Lockup clutch – Reduced rimpull – Throttle lock
Light, dome (cab)
Lunchbox and beverage holders
Mirrors, rearview (externally mounted)
Seat, Cat comfort (cloth) air suspension
Seat belt, retractable, 76 mm (3 in) wide
STIC control system with steering lock
Tinted glass
Trainer seat with lap belt
Vital Information Management System (VIMS) 3G with graphical information display: external data port, customizable operator profiles, cycle timer, and integral Payload Control System (PCS): – Wet-arm wipers/washers (front, rear and corner) intermittent front wiper

Brakes, full hydraulic, enclosed, oil-disc
Axle-shaft oil-disc service brake
Electro hydraulic parking brake
Case drain filters
Cat clean emission module (Tier 4 Final only)
Demand fan
Engine Cat C27
Fuel priming pump (electric)
Ground level engine shutoff, bumper
Mufflers (under hood) (Tier 2 only)
Precleaner, engine air intake
Radiator, Aluminum Modular (AMR)
Separated cooling system
Starting aid, (ether) manual override
Throttle Lock
Torque Converter, Impeller Clutch with lock-up clutch feature and rimpull control system
Transmission, 534 mm (21 in) planetary power shift (electronic) (3F/3R)

Alarm, back-up
Alternator, 150 amp
Batteries, maintenance free (2 – 1,400 CCA)
Converter, 10/15 amp, 24V to 12V
Deutsch component connectors
Electrical system, 24V
Electronic transmission control
Lighting system, halogen (front and rear) lighting, access stairway, engine compartment
Starter, electric
Starter lockout in bumper
Starting receptacle for emergency start
Transmission lockout in bumper

Automatic tilt/lift kickouts electronically adjustable from cab
Axle temperature sensor
Battery disconnect and jump start receptacle, bumper
Coupling, Caterpillar O-ring face seals
Economy mode with on demand throttle
Emergency platform egress
Engine, crankcase, 500 hour interval with CH4
Engine idle management features: – Auto idle kickdown – Delayed engine shutdown – Engine idle shutdown
Fenders, steel (front)
Guards, crankcase and power train
Grouped/labeled lube points
Hitch, drawbar with pin
Hoses, Cat XT^™
Oil sampling valves
Positive flow control hydraulic system
Product Link
Sight Gauges: hydraulic tanks, steering/fan and implement/brake, and transmission
Stairway, left and right rear access
Steering, load sensing
Toe kicks
Vandalism protection caplocks
Venturi stack
Premixed 50% concentration of extended life coolant with freeze protection to –34° C (–29° F)

Optional Equipment:

Standard and optional equipment may vary. Consult your Cat dealer for details.

–50° C (–58° F) antifreeze
Engine oil change system, high speed, Wiggins
Engine block heater 120V or 240V
High ambient cooling – software

Cab precleaner
AM/FM/CD/MP3 radio
Satellite Sirius radio with Bluetooth
LED warning strobe
CB radio ready
Window sun shade

Front and rear roading fenders
Fast fill fuel system (Shaw-Aero)
Axle oscillation stop
Heavy duty cab mounts

What Our Customers Are Saying About Us

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.